# Installation

In this step, we’ll show you how to integrate your ENLYZE Edge device **Edge Device** into a network with internet access and successfully connect it to the **ENLYZE Manufacturing Data Platform**. For the setup, you will use the **ENLYZE EDGE interface**, which you can access locally via your browser.

## Before You Begin

{% hint style="info" %}
This guide describes the installation via a **wired Ethernet connection** using a standard network cable.

🔧 **Wi-Fi setup is currently not supported** via the ENLYZE EDGE interface.

If you require a Wi-Fi-based setup, please contact our support team:\
📧 [**support@enlyze.com**](mailto:support@enlyze.com)
{% endhint %}

Please go through the following checklist to ensure all requirements for a successful integration are met:

### Checklist

* [ ] **Installation location is defined**
* [ ] The following conditions are met at the installation site:
  * [ ] **Power outlet** for power supply is available
  * [ ] **Access to the internet** network (e.g., company network)
  * [ ] **Access to the machine network** or direct connection to the data source (PLC, sensor, etc.)
* [ ] The networks the Edge Device will be integrated into **are be outside of `10.21.0.0/16`**
* [ ] Necessary **firewall rules are configured** based on the MAC addresses provided via email
* [ ] Edge Devices are **whitelisted** in the network infrastructure and excluded from **"UDP Flood Attack Protection"**
* [ ] **IP address allocation is clarified** – if static IPs are used, your IT has provided the CIDR and gateway IP for each device
* [ ] A laptop with an Ethernet port and permissions to configure the network adapters on your laptop
* [ ] Two Ethernet cables to connect the Edge Device to your laptop and to the internet

***

## Establishing Power and Network Connections

In the following steps, you’ll connect the Edge Device to the internet and your laptop, and supply it with power. These steps should ideally be performed directly at the installation site.

#### Device Overview

Below is a schematic showing the Edge Device and its available ports:

<figure><img src="https://4261006941-files.gitbook.io/~/files/v0/b/gitbook-x-prod.appspot.com/o/spaces%2FSNEuiyRRKwuqtIcaEt45%2Fuploads%2F6o1KRQLmBOVDof1s6KtA%2Fgrafik.png?alt=media&#x26;token=eaf019da-f919-4634-843c-ca37de7a185f" alt=""><figcaption><p>Schematic illustration of Edge Device ports</p></figcaption></figure>

1. **Connect the Edge Device to an internet network:**\
   → Plug one Ethernet cable into the port labelled **“Internet”** on the Edge Device and connect the other end to a network with internet access.
2. Connect the Edge Device to a **power source.**

The Edge Device will now boot automatically. Green LEDs on the front left indicate the startup process. The boot process may take up to **5 minutes**.

In the next step, we will connect the Edge Device to the Manufacturing Data Platform. Click **Next** to continue.